International Journal For Multidisciplinary Research

E-ISSN: 2582-2160   •   Impact Factor: 9.24

A Widely Indexed Open Access Peer Reviewed Multidisciplinary Bi-monthly Scholarly International Journal

Call for Paper Volume 8, Issue 6 (November-December 2026) Submit your research before last 3 days of December to publish your research paper in the issue of November-December.

Effect of Solidification Kinetics and Vickers Indentation Conditions on Mechanical Properties of Sn-Bi-Cd Alloy

Author(s) Rajesh Kant
Country India
Abstract The present work examines the relationship between anisotropic growth velocity and the mechanical behaviour of the Sn–Bi–Cd eutectic composite. The alloy was prepared from the constituent metals using the heat-chill method and its eutectic melting point was determined by differential scanning calorimetry. The composition investigated was Sn 25.9 wt%, Bi 53.9 wt%, Cd 20.2 wt%, with a measured eutectic melting point of 376.2 K. Macrohardness-related strength modes and Vickers microhardness were evaluated as functions of growth velocity, indentation time and applied load. At 3.10 × 10⁻⁷ m s⁻¹, the modulus of rupture is 52.10 × 10⁵ N m⁻², tensile strength is 63.90 × 10⁴ N m⁻² and compressive strength is 66.30 × 10⁴ N m⁻². Microhardness rises from 16.40 kg mm⁻² at 0.50 × 10⁻⁷ m s⁻¹ to 35.30 kg mm⁻² at 3.10 × 10⁻⁷ m s⁻¹ and decreases to 17.10 kg mm⁻² at 7.50 × 10⁻⁷ m s⁻¹. At 20 g, Hv remains approximately 34.50–34.80 kg mm⁻² over 20–150 s. Hv decreases from 36.50 kg mm⁻² at 10 g to 16.70 kg mm⁻² at 100 g. The results demonstrate a characteristic optimum or moderate-growth region in which the fibrous eutectic microstructure and mechanical response are maximized. The observations support the manuscript’s interpretation that directional/fibrillar growth produces stronger, more coherent microstructures than instantaneous or very rapid growth.
Keywords eutectic composite; anisotropic growth; growth velocity; macrohardness; microhardness; Vickers hardness; fibrillar microstructure.
Field Chemistry
Published In Volume 4, Issue 3, May-June 2022
Published On 2022-05-27

Share this